TSO'd REGULATED E/L PANEL INVERTER
0-115 Vac Electroluminescent Lamp Power Supply
The SD3 is a pulse width modulated dc to ac converter that provides regulated 0 to 115 Vac power up to 0.26 amperes for EL panel lighting. The SD3 will power approximately 160 in2 to 220 in2 area of a EL panel.
The output voltage is varied by a slider voltage 0-5 Vdc applied at pin F from a remote control potentiometer 5K ohm 1/2 watt to ground or directly from a 0-5 Vdc source.
An internal trim pot is provided to adjust the output voltage ± 10% at its full clockwise position of the external pot.
Circuit protection includes low input voltage shutdown, soft start, high input voltage shutdown, output over voltage limit and output short circuit current limit
Specifications: | |
Input Voltage: | 28 Vdc NOM., 24 to 32 Vdc |
18 Vdc to 36.4 Vdc (Abnormal Range) | |
Input Current: | 0.6 Amp typ at 30VA EL load at 28Vdc 0.4 Amp maximum at no load |
Output Voltage: | 0-115 Vac regulated |
Output Current: | 0-.26 Amps continuous |
Frequency: | 400 Hz ± 2% |
Distortion (THD) | 5% typ at 28 Vdc @ 30VA, -.2pf load |
Power | 30 VA maximum for EL panel |
Power Factor: | Zero to –0.2 leading (capacitive) |
Regulation: | 5% for load, 3% for line and 3% for temperature |
Control: | Output voltage 0-115 Vac is controlled by an external 5 KW potentiometer or a 0-5 Vdc source applied at pin F. |
Isolation: | Output is isolated from input. |
Overload(OL): | Deliver 150% output current for 5 min. |
Protection(OL): | Withstands without damage or degradation load exceeding 150% (-.2pf) to an output short circuit. Unit delivers rated output power upon removal of the overload condition |
Protection(SC): | Under a output short circuit condition, the input current folds back and the output current is limited to a safe value |
Protection(OV): | Output voltage is limited to 145 Vac maximum |
Soft-Start: | Minimum soft start delay of 100 mSec at full load is provided during an application of step input voltage to reduce output in rush current to EL panel. |
Shutdown(SD): | Output shuts down when input voltage is below 14 Vdc and above 36.4 Vdc. |
Temperature: | -55° C to +71° C |
Altitude: | 55,000FT |
Connector: | Unit mates with MS3106A14S-6S |
Finish: | Gold iridite per MIL-C-5541 Class 1A |
Compliance: | FAA TSO-C73 |
Weight: | 1 LB (454 grams) |
Size: | 2.00 H x 3.18 W x 5.00 L inches |
50.8 H x 80.8 W x 127.0 L mm | |
Less protrusion of connector and screw heads |