SPC6-1000-3PH
FREQUENCY CHANGER
50-60 Hz to 400Hz, 3 Phase
The SPC-6-1000-3PH solid state frequency changer converts 115 VAC 50/60 Hz to 115/200 VAC and 26/45 VAC, 400 Hz 3Ø sine wave power. The SPC-6-1000-3PH is designed for use on test benches to check radars, compasses, gyros, synchros or any instrument requiring 3 phase power.
The SPC-6-1000-3PH-230 and SPC-6-1000-3PHC are frequency changer models available for 230 VAC 50 Hz operation.
Specifications
Input Voltage
115 VAC ± 15 VAC
115 VAC ± 15 VAC
Input Frequency
50/60 Hz
50/60 Hz
Input Phase
Single
Single
Input Protection
Protected from input overvoltage (unit will shut itself off above 135 VAC). Protected from overcurrent with 20 amp. circuit breaker. This circuit breaker is also used for the input power on-off.
Protected from input overvoltage (unit will shut itself off above 135 VAC). Protected from overcurrent with 20 amp. circuit breaker. This circuit breaker is also used for the input power on-off.
Output Voltage
- 115/200 VA
(100 to 125 VAC L-N) adjustable - 115/200 VA
(173 to 216 VAC L-L) adjustable - 26/45 VA
(22.6 to 28.2 VAC L-N) adjustable - 26/45 VA
(39.1 to 48.8 VAC L-L) adjustable
Output Power
- 115 VAC ...1000 VA Total
(330 VA / phase) - 26 VAC ... 225 VA Total
(75 VA / phase)
Output Frequency*
400 Hz (380 to 420 Hz) adjustable
400 Hz (380 to 420 Hz) adjustable
Phase
3 Phase
3 Phase
Wave
Sine
Sine
Amplitude Distortion
2% T. H. D. typical
2% T. H. D. typical
Power Factor
.8 to -.95
.8 to -.95
Overload
Delivers 150% overload for at least 5 minutes. Withstands short circuit for 1 minute minimum.
Delivers 150% overload for at least 5 minutes. Withstands short circuit for 1 minute minimum.
Temperature
-40°C to +71°C
-40°C to +71°C
Weight
35 lbs.
35 lbs.
Cooling
Internal fan thermosatically controlled.
Internal fan thermosatically controlled.
Protection
Unit will shut itself off under the following conditions:
Unit will shut itself off under the following conditions:
- Under frequency (below 375 Hz).
- Over frequency (above 425 Hz).
- Over voltage (above 130 VAC).
Connections
Front panel mating connector: MS3106A24-11P
Rear panel 6-32 Terminal block.
Front panel mating connector: MS3106A24-11P
Rear panel 6-32 Terminal block.
Size
17"W x 13"D x 7"H for 19" relay rack mounting.
17"W x 13"D x 7"H for 19" relay rack mounting.
* Adjustable from front panel.
